Recall 07-026, published November 8, 2006
DeWalt DW378G/DW378GT Framing Saws and DC300 Circular Saws
Compare the model on your label, then check any serial numbers, date codes, and exclusions in the notice. A model match alone does not confirm that your unit is included.
Affected model numbers
DC300Circular saws involved in this recall have model number DC300 with date codes 200601-49 through 200637-49.
Which products are included?
This recall involves DeWalt DW378G and DW378GT 7 ¼-inch framing saws with date codes 200301-49 through 200637-49. The model numbers for the framing saws are located on the side of the housing. The date code is located either on the name plate or under the handle near the power cord exit. Circular saws involved in this recall have model number DC300 with date codes 200601-49 through 200637-49. The model number on the circular saw is located on the name plate on the top of the motor housing. The date code on the circular saw is located on the underside of the motor housing. Framing saws marked with a "V" on the underside of the handle near the cord set and circular saws marked with a "V" on the underside of the motor housing or under the handle where the battery is inserted have already been repaired and are not involved in this recall.
Confirm these details on the official CPSC noticeWhy it was recalled
The lower blade guard can fail to close, leaving the blade exposed and presenting a laceration hazard to consumers.
Official remedy
Consumers should stop using the saws immediately and contact DeWalt for a free repair.
- Brand
- DeWalt
- Recall published
- November 8, 2006
- Category
- Power Tools
- Units
- About 97,000 framing saws and 37,000 circular saws
- Sold at / sales period
- Major home centers and hardware stores nationwide from January 2003 through August 2006 for about $170 for the framing saw. The circular saw was sold from May 2006 through September 2006 for between $380 and $800, depending on the kit.
